Compounds and Isolation

The muscles the big lifts leave behind.

What do compound lifts miss?

A loaded barbell resting on a jack on the gym floor

“Squat, press and pull, and the small muscles look after themselves.” It is efficient advice and mostly true. The exceptions are specific, and they are the reason isolation work exists.

What the research shows

Ten weeks of squatting grew the quadriceps as a group, the glutes and the adductors. It did not grow the hamstrings, and it did not grow the rectus femoris, the one quadriceps muscle that also crosses the hip.

In a separate trial that compared squats with leg extensions, the rectus femoris grew along its whole length with leg extensions and did not grow with squats.

The triceps behave the same way. Bench pressing grew the outer head of the triceps well. The long head, which crosses the shoulder, grew more in every group that did a triceps extension than in the group that only benched.

The biceps evidence is mixed, which is worth knowing. In one study new lifters rowed with one arm and curled with the other for eight weeks, and the biceps of the curling arm grew about twice as much. In another, new lifters gained the same biceps size from pulldowns as from curls. Both were small studies.

Biceps growth: a pulling lift against a curl
Eight weeks, one arm on each
  • Biceps curl+11.1%
  • Dumbbell row+5.2%
Ten weeks, two groups
  • Biceps curl+5.8%
  • Lat pulldown+6.1%

Mannarino et al. (2021), Gentil et al. (2015)

Why it happens

The usual explanation is that a muscle crossing two joints gets caught between them. As you stand up out of a squat, the hamstrings shorten at the hip while they lengthen at the knee, so they change length very little and do little of the work. The rectus femoris has the same problem in a squat, and so does the long head of the triceps in a press.

A helper muscle is also rarely taken near its own limit. The set ends when the main muscle does.

What Stimuli does with it

Helpers get a share, not a full setEvery lift is credited to the muscles that drive it, most to the main mover and less to the helpers. On a bench press that is the chest first, with the shoulders and triceps behind it. In the same way a row counts toward your biceps, but not for as much as a curl does.
The Week tab shows the gapsUnder Set ranges, a muscle that only ever works as a helper tends to sit below its productive zone while the main movers land in theirs. That is the cue to give it a direct exercise.
Programs fill them inThe programs Stimuli builds start from compound lifts and add isolation work where a muscle’s week would otherwise fall short.
A sound default: compounds for most of your sets, then one direct exercise for each muscle you care about that compounds only brush. The hamstrings, the long head of the triceps and the biceps are the usual candidates.
For how one set is shared between muscles, see the “Training Volume” guide.

Sources

  1. Kubo K, Ikebukuro T, Yata H (2019). Effects of squat training with different depths on lower limb muscle volumes. European Journal of Applied Physiology.
  2. Zabaleta-Korta A et al. (2021). The role of exercise selection in regional muscle hypertrophy: a randomized controlled trial. Journal of Sports Sciences.
  3. Brandão L et al. (2020). Varying the order of combinations of single- and multi-joint exercises differentially affects resistance training adaptations. Journal of Strength and Conditioning Research.
  4. Mannarino P et al. (2021). Single-joint exercise results in higher hypertrophy of elbow flexors than multijoint exercise. Journal of Strength and Conditioning Research.
  5. Gentil P, Soares S, Bottaro M (2015). Single vs. multi-joint resistance exercises: effects on muscle strength and hypertrophy. Asian Journal of Sports Medicine.

Keep reading

Train with science

Stimuli gives every muscle an Effective Work score as you log sets, and shows you where it landed.

Download on the App Store Get it on Google Play